Tent Pegs I Like & Dislike (with reasons)

Tent pegs ordered as I'd choose them from one I wouldn't use on the left to my favourite on the right.

Tent pegs are essential items you should be able to take for granted. Simple, functional, not particularly interesting. However, I’ve been irritated recently at how many of them are barely adequate, if that.

Tent pegs only have one purpose, to secure a tent or tarp so it doesn’t fall down or blow away. That shouldn’t be difficult. And for many years it wasn’t. Pegs for backpacking and mountaineering tents were mostly of two sorts – pin or skewers pegs with shepherd’s crook heads and U or V-shaped pegs with bent over tops. Made of aluminium both sorts were lightweight and suitable for all but the softest ground if long enough. Attaching guylines and pegging points securely was easy. Using them was easy.

These pegs are still around and better and cheaper than most modern styles. For example, Vango Pin Pegs have shepherd's crook tops. They are 18cm long, weigh 12g each, and cost £4.99 for ten from Ultralight Outdoor Gear (all prices in this article are from Ultralight Outdoor Gear and are current for mid-August 2026). Such pegs are plain and dull – as tent pegs should be! You can spend £20-£50 or more for ten modern pegs that look much fancier, most of which aren’t as good as the Pin Pegs, though they usually weigh a little less. I’m much more concerned that a peg will hold my tent up than that I’m saving 6g. 

The Pin Pegs are tubular aluminium like my old ones. There are much thinner titanium shepherd's crook pegs - you can see three on the left of the picture at the top. The longer ones are okay in hard ground though I wouldn't use them for anything other than the corners of a tent or for a groundsheet inside a tarp. Being titanium they are very light - 6-9g.

Too many of the latest pegs are too short and have notched tops that guylines and pegging points can easily slip off. I’ve tested six backpacking tents in the last year and only one had adequate pegs, and that was by far the least expensive one. The others were all too short and had tiny notches for attaching pegging points. They are brightly coloured though with the brand name embossed on the side.  

One set did have bigger notches at the head that did hold guylines better, until they broke or bent that is. Because the notches were deeper only a narrow section of the peg was left between them so when pressure was applied, the head tore and bent.  Four failed like this on a winter camp on stony ground high in the Cairngorms. It could have been awkward, but I always carry extra pegs, so I replaced them with shepherd’s crook ones.

One of the pegs that broke and the replacement I was glad I had.

Another problem with many modern pegs is that the heads can be quite hard and sharp, so they hurt or even cut your hands when you apply pressure to them. I’ve seen suggestions for using a plastic bottle cap or a thimble to put over the peg, so it doesn’t hurt your hand. This isn’t necessary with old-style pegs!

The short length (under 16cms) of many of these pegs means that they don’t hold well except in very hard ground. The wind tugging on guylines can pull them out.

It’s annoying that too many expensive backpacking tents come with these pegs, so you need to replace them or at least add better pegs for the main pegging points and guylines. This should not be necessary.

 

My favourite peg on the right. Two of the short, tiny notch Y-pegs that come with many modern tents.

The pegs I find best of all are long tubular ones. These hold well in all types of ground from soft to rock hard and the ones I've used are very tough. There are several brands. Mine are Easton. They’re 22cm long and weigh 15g each. I’ve been using them for many years and they’ve never failed, though I have bent one. It’s still usable.  Current ones are a bit longer at 23cm and a bit lighter at 13g. They are expensive though. £6.49 each for an Easton Nano one.  

As Easton pegs have apparently been discontinued if I was replacing them it would be with the 20cm Big Sky International Tube Steak 20 which weigh 14g per peg and cost £16.99 for a pack of four.

I don’t carry enough tubular pegs for every pegging point and guyline. That’s unnecessary. I carry enough for key stress points and shorter, lighter pegs for everywhere else.

I’ve also made a YouTube video about pegs.